What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
15.06.2025 05:19

He then asserts :
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The bolt then partially travels down the line to your home.
New paper pushes back on Apple’s LLM ‘reasoning collapse’ study - 9to5Mac
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
In schematic diagrams this is the symbol for a fuse:
Now when you have a certain ac resistance, then a current flows in a loop.
What are some reasons why men may not want to date a woman who can pay her own bills?
so, what happens?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But… the neutral is now “floating” because of the 1 ohm resistance.
Why are the Chinese so sensitive to Western criticism?
An AC voltage/ current source, and an ac inductive load.
The other is “what does a “fuse” do?”
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Edit 2024–10.
It also is a device that limits the change in current flow.
How do you write lyrics for a song that resonates with listeners?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–14 [Omar Gharbi Omar Gharbi ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Because the load is inductive, the current lags the voltage.(by a bit).
Here is a simplified AC power diagram.
What is lightning?
What would you do if you found out that someone had broken into your home while you were sleeping?
The MOV will conduct when the voltage exceeds 50% of line voltage.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Star Trek: Strange New Worlds is getting a fifth and final season - The Verge
but I think this circuit , shows a few more pieces.
I post the exact comment here.
This is where this question deviates from being a 'generic' question, and becomes more specific.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Do women really cheat more than men?
This is 'the assistant's answer'
There are two important concepts here.
At least they know the answer if they wanted it.
Poop Transplants Not All They’re Cracked Up to Be - Gizmodo
So, the voltage could go up to 500 volts, and the fuse will not open up.
the problem then depends on "how fast does the fuse operate?".
There are three different concepts here that are getting confused.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The third is lightning and “how it gets conducted into a home.”
what exactly is a ‘surge’ protector?
Barnstars:
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
A circuit breaker is similar, but is resettable.
For this case there are devices called Metal oxide varistors (MOV).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
He then describes Rainy Season and Lightning.
Upvotes:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
These devices are installed between the “hot” and “neutral” and protective ground.
What does a fuse do?
He then describes the function of a fuse.
a photo is worth a thousand words.
This device then solves the entire problem.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
First Sentence:
[image of Common-mode choke]
(Dc diagram shown, AC is similar).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It seems Mohan does not understand the difference between a comment and an Answer.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
nine
One is “what exactly is in a ‘surge protector’ ? ”
A fuse is a non-resetable over current circuit protector.
This one hit behind the barn.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
These are simplified answers to the original question, and does not change anything I wrote above.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–16 [ OO OLAOYE OYEBODE ]
This is where the MOV conducts again, and dissipated the energy.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
One
[old diagram got deleted by accident]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–10[John johnson John Johnson ]
eight
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
At one ohm, the resistor has a maximum of 1 watt power.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But it can get overloaded, and no longer works.